Growmanager

Installation: Software

• Start the Installation Wizard
• Give all Sensors (Temp, Humidity, CO2) Names
• Give all Relais Names
• Set the Output Adress (LPT1, etc.) in the Hardware Dialogue
• You're ready to grow!

Note: The Usb-Card and the Webcam has to be connected before you start Growmanager, all other Hardware can be connected later

Installation: Hardware

• Connect USB-Card to PC
• Connect all Temp-Sensors to LPT1
• Connect your Webcam to a free USB port
• Connect Humidity Sensor & Co2 Sensor to USB-Card
• Connect LCD-Panel to LPT2
• Start Growmanager

FAQ:

• Growmanager does not close properly.
  - This bug will be fixed soon, consider closing via Ctrl-Alt-Entf - "End Task"
• Can I adress my own IO Card?
  - You can adress all ranges of Hardware IO-Ports via the hardware Setting. It is recommended to use LPT ports.
• My Webcam does not work.
  - Please install all your webcam driver before you install Growmanager. That should help.
• All Windows/Pages in Growmanager does not load or take too long.
  - Growmanager has to write several Registry-Setting on the Hard-Disk. The first time you do open a window it takes up to 10 secs.
• Growmanager got Error "430" and closes
  - If you installed IOOcx from JSPayne you will need to register the io.ocx that comes with Growmanager.
• I got Labjack - does Growmanager work with this?
  - NO. Growmanager is based on the K8055 USB Board from Vellemann.